These Victorian tiles at a residence in Glasgow went through a dramatic change after we restored the colours and appearance. You can see from the photograph below the tiles were dull, stained and there was also paint splashes in various places.
Cleaning a Victorian Floor
Firstly the floor was swept out and vacuumed to remove all loose debris; we then covered the entire floor with a strong solution of Tile Doctor Remove and Go combined 50/50 with NanoTech Ultra Clean which was left to dwell on the floor for an hour so it could soak into the tile. This floor did not have a previous sealer applied however the solution helped to break down the ground in dirt in the tiles and also remove the paint splashes.
The dirty solution was then extracted off using a wet vacuum and the floor rinsed with clean water several times to remove any chemical residue. Next we mixed a 50/50 solution of Tile Doctor Pro Clean and NanoTech Ultra Clean which was then scrubbed into the tile using a black scrubbing pad on a rotary machine. This was then removed and floor rinsed again and the floor was cleaned a further three times using a strong solution of Tile Doctor Pro-Clean and extracted with a wet vacuum again followed by a mopping of Neutral Tile Cleaner.
Sealing a Victorian Floor Sealing
Once the floor was dry it was then sealed using four coats of Tile Doctor Seal and Go to achieve the finished result. I recommend Seal and Go for Victorian tiled floors as it leaves a low sheen finish whilst providing excellent stain protection.
Quarry Tiles and Victorian Tiles seem to be a magnet for paint, you would of thought people would take more care when decorating.